Raspberry Pi Compute Module 4 Nano Base Board (A) (21634)

Raspberry Pi Compute Module 4 - not included in the package!

The Raspberry Pi Compute Module 4 Nano Base Board (A) (21634 ) is a base board for the Compute Module 4 Lite/eMMC, suitable for evaluating the Raspberry Pi CM4 compute module or for integrating it into end products. The Nano Base Board has the dimensions of the computing module. A 40-pin GPIO pin connector is included, which can be soldered on the board for ease of use, but is not installed by default for reasons of reducing board size.

See the technical specifications:

Interfaces:

1. CM4 connector fits all Compute Module 4 variants
2. USB Type-C connector for Power/Programming (5V power supply or used for eMMC writing)
3. Micro SD card slot for connecting a Micro SD card with a pre-recorded image (Lite version ONLY)
4. CSI connector. MIPI CSI camera interface
5. USB2.0 connector for connecting various USB devices
6. 40PIN GPIO connector for connecting various expansion cards
7. PWR indicator. CM4 power supply status
8. Indicator ACT. CM4 operating status
9. AMS1117-3.3
10. BOOT switch
ON: Switches USB to Type C interface, enters boot mode after power on (configured as a high capacity disk via RPI boot)
OFF: switches USB to type A interface, does not enter boot mode at power on (boots from eMMC or Micro SD card)

Overall dimensions: 55 mm × 40 mm

Information for developers (Wiki): CM4-NANO-A

The package includes:

1. CM4-NANO-A x1
2. 2*20PIN colored straight male connector x1

1. 2.

Weight: 0.014 kg